8/31/2023 0 Comments Routeros 7 wireguardOtherwise they all need to be configured on the default WireGuard group that OPNsense creates. I had been hoping Ubiquiti would add Wireguard to the UniFi USG so I could try it out since the version of strongSwan they ship is embarrassingly out of date, but it seems like they have mostly abandoned that product. Second, it automatically adds an IPv4 outbound NAT rule, which will allow the tunnel to access IPv4 IPs outside of the local network (if that is desired), without needing to manually add a ruleįinally, it allows separation of the firewall rules of each WireGuard instance (each wgX device). I happened to be upgrading some Mikrotik routers from RouterOS 6 to 7 and noticed they added Wireguard support. Under Interface select the newly created WireGuard interface. Add WireGuard IP address 10.100.100.2/24 to RouterOS. Otherwise you will need to define your own alias or at least manually specify the subnet(s) To make the router aware of its new IP address on the WireGuard network, go to IP > Addresses and add the address 10.100.100.2/24: Add WireGuard address range to RouterOS. However, it is useful to implement, for several reasons:įirst, it generates an alias for the tunnel subnet(s) that can be used in firewall rules. This step is not strictly necessary in any circumstances for a road warrior setup. Whats new in 7.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |